Madbull 60 Degree Shark Accelerator Hopup Bucking (Red)

Madbull 60 Degree Shark Accelerator Hopup Bucking (Red)

Madbull 60 Degree Shark Accelerator Hopup Bucking (Red). Softer rubber construction with shark-fin internal teeth for aggressive backspin on heavy BBs (0.28g+). 60 Degree rubber is softer than standard 80-90 degree rubber, making it easier to install and providing better air seal on lower-FPS setups. Includes 2x hop-up rubbers. Compatibility & Application Guide Compatible Platforms Platform Model Variant Notes Tokyo Marui M4/M16 AEG All variants Direct fit, standard AEG cut Tokyo Marui AK AEG AK47 / AK74 / AK102 Direct fit, V3 gearbox compatible CYMA / JG / G&G AEG M4/M16 pattern Compatible with most TM-spec AEG hop chambers Which Hardness Should You Choose? Degree Best For Trade-off 60° (this product) Standard AEG, sub-400 FPS, 0.20-0.28g BBs Softer seal = more consistent hop on lightweight ammo; faster wear than harder compounds 70-80° (Blue/Purple Shark) 400+ FPS, DMR builds, 0.30g+ BBs Durable under heavy spring loads; may over-hop light BBs Common Pairings (based on verified customer orders at eHobbyAsia) MadBull Shark Bucking + PDI 6.01mm Inner Barrel, precision barrel + aggressive bucking for accuracy-focused DMR builds MadBull Shark Bucking + Prometheus Flat Nub, flat-hop conversion for heavier BBs without replacing the entire chamber GBB Compatibility Warning GBB users : This is an AEG-cut hop up bucking. Most GBB pistols (Hi-Capa, Glock, 1911) use VSR/G-Series cut buckings. Verify your hop chamber cut type before ordering. CO2 users : Higher pressure can accelerate wear on 60-degree rubber. Consider 80-degree alternatives for CO2 setups.

Brand
MadBull
Category
gear
From
11.02 USD

Where to buy

Specs

FITS MANY MODELS